If your Maytag Dryer is not drying and the timed dry cycle is also not working, check the thermal fuse which you can find on the vent duct that is inside the dryer. To see if it has blown, check with a multimeter for continuity. If the fuse is blown there will be no continuity.
If your GE Dryer is not working and keeps stopping, first check for a blocked vent. If the dryer’s generated hot air can not exit due to a blocked vent, it will cause activation of the thermal overload switch in order to stop the dryer to prevent a thermal fire.
If your Bosch dryer is not drying and not blowing air, unplug the dryer and move the dryer so that you can remove the vent from the dryer. Take off the vent screen from the outside and use a vacuum cleaner to take any lint out of the vent. Then reconnect the vent.
If your Bosch Dryer is not working, it could be from a thermal fuse that has either burned out. Once you see where the thermal fuse is located inside the dryer’s cabinet, test it with an electrical multimeter to check the leads for continuity. You will need to replace it if this is the issue.
If your Amana Dryer is not working, the first place to look is with the power. If you are not getting power to the machine, such as with a faulty cord, breaker, or receptacle, it should be fixed. Otherwise, it could be a problem with the door latch or the thermal fuse. Any of these is fairly easy to fix.
Anytime your Amana dryer is not heating or drying, it is likely a problem with the settings. You can cycle between auto dry and timed dry, but you should generally use the auto dry feature. If you find that it is taking too long or the dryer is not heating properly, make sure that you have it set on the proper load cycle.
If your Frigidaire Washer is not draining it could be a problem with the drain pump not working properly. The drain pump can be found at the bottom of the washer. If you pull the washer forward you can easily remove the drain pump. If there are not any obstructions in the drain pump, and it is still making strange noises as it drains it is probably time to replace it.
An error beep is a signal that alerts you to a problem with the washing machine. If it is beeping continually, you may need to replace the control board. If the machine is working otherwise, you can always turn off the beeping noise by holding down two buttons simultaneously. Check the manual for the specific buttons.
This could be due to a major problem with the spinner support that is located on the posterior side of the spin basket. To check this you can determine if the spin basket moves too much as you rotate the basket around. If there is too much laxity then the spinner support will need to be replaced.
A Kenmore dryer will not heat with a broken heating element, blown thermal fuse, malfunctioning thermostat, faulty power supply or broken control board. Besides lack of heat, your clothes will also not dry if there is reduced air flow, the clothes do not move or the moisture sensor is broken.