If your Dyson stick vacuum clogged, remove any obstructions in the wand, hose, and brush attachment. Keep the dirt canister clean. Regularly wash and dry the filters. If the vacuum has overheated due to a clog, allow the vacuum time to cool and recharge before using again.
Overall, start by checking that the wall outlet your Eureka vacuum is plugged into has power. Plug something else into the same wall outlet and see if it works. If it does, then typically the thermal cutoff is stopping your Eureka vacuum from turning on, wait 24 hours and try to turn it on again.
Generally, this is caused by the roller having hair or too much debris stuck in it, as well as hair wrapped around the sides, and/or on the inside of the roller. All of which needs to be removed. Otherwise, the brushroll button isn’t turned on, and needs to be pressed to turn the rollers on.
A broken latch is typically the cause of a Shark Rocket vacuum that won’t stand up. Unfortunately, this problem cannot be fixed without first calling Shark’s customer service to obtain a replacement for the latch. The latch may be under warranty, depending on when you purchased the vacuum. You can also purchase a replacement latch on the Shark’s official website or through Amazon.
Generally, this is because the suction is turned down too low, it’s on the wrong mode, or one or more of the components is clogged. Parts that can be clogged are the 3 sets of filters, the hoses, the opening at the base, and the brush roll. Check each and clear/clean them where necessary.
If your Dyson cordless vacuum keeps shutting off, the motorhead could be malfunctioning. If the filter was not fully dry before returning it to the vacuum, the water from the filter could have caused a short circuit and damaged the motor, causing it to shut off.
If your Dyson cordless vacuum won’t open, apply more pressure to the red clip. The clip is meant to provide a secure seal so the bin will not be accidentally released while the vacuum is in use. If applying more pressure does not work, use a flat head screwdriver to pry the clip open.
You can prolong the lifespan of your Dyson cordless vacuum battery by letting the battery completely run down at least once a month. Store the vacuum in a room temperature setting. Do not use the High Power Mode setting often. Let the vacuum cool down before charging.
Shark Navigator vacuum overheating problems are usually caused by debris blocking the pipes or the filters. Switch off the vacuum cleaner and remove the hoses. Check them for blockages and clean out the filters. Finally, check the plastic elbow at the bottom, as it is a common site for blockages.
If your Shark vacuum is not working, there could be an obstruction within the hose, the brush roller, or in the dust cup air duct. Issues may also be caused by a need for proper charge, clean filters, or a nozzle that has not been fully engaged which will prevent the vacuum from operating properly.